The ZEEZ F7 V3 3030 is an 8 Motor Output, DJI HD System Ready Flight Controller with an on-board 9V@3A regulator to power the DJI Air Unit, with a simple plug and play configuration and 5V@3A regulator to power all the peripheral.
It uses a powerful F7 processor along with top-of-the-line hardware:ICM42688P Gyro, BMP388 Barometer, with a separate power rail for cleanest data. The ZEEZ F7 V3 3030 comes in a standard 30x30 form factor. It comes with spaces and pads for TBS Crossfire and TBS Unify Nano32 for a very clean and low-profile assembly. We have added a connector for a 2nd ESC to make building X8's as easy as possible. There are 5 UARTS available as well as, I2C port, SD CARD for Blackbox data record, an OSD chip for analog video.
Features
• Mounting holes: 30.5x30.5mm
• LiPo Power input: 3S-6S
• 8 Motor output
• BEC 5V-3A / 9V-3A
• STM32F722 MCU (216MHz max frequency)
• ICM42688P Gyro/ACC
• BMP388 Barometer
• OSD chip Onboard
• 5 available UARTs / I2C bus
• SD Card Reader
• HD Plug for DJI Air Unit or Caddx Vista or Walksnail VTX
• USB Type C connector
• Direct solder connection and board space for TBS
Nano RX and TBS Unify Pro32 Nano
providing the ultimate in clean stack installation.
Package includes:
(1X) Zeez F7 V3 3030 Flight Controller
(4X) Aluminum Standoff
(4X) Aluminum Nut
(1X) ESC to Flight Controller 8 Pin to 8 Pin JST SH 1.00mm connector
(1X) ESC to Flight Controller 8 Pin to Free wires (with JST SH crimp)
(1X) 2nd ESC to Flight Controller 5 Pin to 8 Pin JST SH 1.00mm connector
(1X) 2nd ESC to Flight Controller 5 Pin to Free wires (with JST SH crimp)
(1X) JST SH 8 Pin Plastic Housing
(1X) JST SH 10 Pin Plastic Housing
(2X) 2.00mm Header Pin for VTX connection
(2X) 2.54mm Header Pin for Receiver connection
(1X) JST 6 pin to AirUnit Connector
