WhitenoiseFPV TBS Unify Mounting Board w/ RealPit
Features / Uses:
Plug in your VTx at any time with 0 power start-up
FlightOne may have a split-second power up on boot up. Some VTXs may transmit during that time.
Turn off your VTx on the line to avoid heat buildup
Fast Team Race Pit stops (Sub second transitions possible)
Compatible with TBS Unify Nano, 5v Pro, HV v3
Mounting for Receiver on bottom of board. XM+ or XF easy mount
Turn off VTx during races to test hover builds without interfering with other pilots in the air.
Turn off VTx after Crash for clean video for other racers.
Solo Endurance Races, 3 quads ready on the line. Practice for more than 1 pack without taking off goggles. (Instructions on how to setup on OpenTX / Spektrum Coming soon)
LED Indicator light on board. (Light On \ Power On)
Can be used on any pad on Betaflight Flight Controller.
BUILT-IN capacitors for 5v camera/vtx power and Lipo battery voltage. (Clean up video lines)
Please see Image for Pin-Out Diagram
Currently Supported Software:
Betaflight (PinIO)
Butterflight (PinIO)
FlightOne 1.2.4+ (PINTOGGLE)
Operating Voltage: 5V - 28V (HV-6s) 1Amp Switch
Dimensions: 36 x 36 x 2.5 mm
Weight: 2.5 Grams w/ Heatshrink
Contents:
1x Realpit
1x 1/2" Heat shrink piece
Betaflight Settings:
In CLI:
Type RESOURCE
Locate UART TX/RX pad resource ID you are using. We wired to RX4 in this demo. RX4 is A01 Note the name of resource and ID.
Next we will clear that pad from its assigned resource.
Type
RESOURCE SERIAL_RX 4 NONE
Next we will set the Custom Mode Switches. We will set up 4 switches for up to 4 Realpits. Copy and past these Commands into CLI:
set pinio_box = 40,41,42,43
aux 2 40 2 1600 2100 0
aux 3 41 3 1600 2100 0
aux 4 42 4 1600 2100 0
aux 5 43 5 1600 2100 0
Next we need to assign the Resource ID to the Custom Mode switch. Using the Resource ID from above. "A01"
resource PINIO 1 A01
If you wish to set up more pads for additional RealPits. replace the area in brackets with your resource IDs:
resource PINIO 2 [resource=I.E=A04]
resource PINIO 3 [resource=I.E=A05]
resource PINIO 4 [resource=I.E=A06]
Type SAVE in CLI and then press enter. Your FC will reboot after applying changes.
Now go to Modes and Assign an AUX channel to the USER1 mode. Just like an arm or turtle mode switch. Click SAVE.
Now flip the switch and test. A RED LED will be lit on RealPit if your are providing power.